Contact Us
TEL: 86-010-82675282
Fax: 86-010-82675633
E-mail: susan@kaida17.com
Address: Floor 2, Building C, No. 3 courtyard, Jinbangyuan North Street, Xisanqi, Changping District, Beijing 100096, PR CHINA
Home > Knowledge > Content
How to identify the pros and cons of the Leeb hardness tester
Dec 07, 2018

How to identify the pros and cons of the Leeb hardness tester


The true Leeb hardness tester is in line with national and international standards and is interchangeable. Although the relevant Chinese departments have established the national standard for the Leeb hardness tester, some manufacturers' technical strength is not up to the standard of the standard Leeb hardness tester. Therefore, the revised method is used to produce the Leeb hardness tester. The Leeb hardness tester, but far from the true Leeb hardness tester, the hardness tester with the original measurement error can also meet the exact requirements of the test hardness test block after correction. Therefore, the user should choose the good hardness tester. The following features of the true Leeb hardness tester:


1 Impact device is interchangeable. A host of the Leeb hardness tester can be equipped with seven different types of impact devices at the same time; several impact devices of the same type can be configured on a single host.


2 The punch of the impact device is replaceable. The punch of the Leeb hardness tester impact device is replaceable. The punches of the same type of impact device can be replaced with each other without affecting the measured value.


The 3 Leeb hardness tester does not have adjustability. The Leeb hardness tester does not have adjustability after leaving the factory. If the measured value is not accurate due to the wear of the ball head, it should be solved by replacing the ball head.


4 Leeb hardness tester measurement error meets the standard requirements in the full range of hardness. The measurement error of the Leeb hardness tester ranges from low to high throughout the hardness range to meet the error requirements specified by the standard.


Previous: Roughness meter repair

Next: Factors affecting the measurement data of the coating thickness gauge