Contact Us
TEL: 86-010-82675282
Fax: 86-010-82675633
E-mail: susan@kaida17.com
Address: Floor 2, Building C, No. 3 courtyard, Jinbangyuan North Street, Xisanqi, Changping District, Beijing 100096, PR CHINA
Home > Knowledge > Content
Roughness Tester operation steps
Nov 29, 2018

Roughness Tester operation steps


Let's talk about the following steps, the operation steps of the roughness meter


1. Measurement preparation


Turn on the battery to check whether the battery voltage is normal; wipe the surface of the workpiece to be tested; place the instrument correctly, smoothly and reliably on the surface to be tested; the sliding track of the sensor must be perpendicular to the processing texture of the surface to be measured.


2. Switching machine


The instrument will automatically turn on after pressing the switch key for about 2 seconds. After the power is turned on, the instrument model, name and manufacturer information will be displayed, and then the main display interface of the basic measurement state will be displayed.


3. Contact pin position


First, use the stylus position to determine the position of the sensor. Try to make the stylus measure in the middle position. In the main interface state, press the stylus position key to switch the stylus position display interface and the main display interface.


4. Start measurement


In the main interface state, press the start measurement button START to start measurement


5. Measurement results display


After the measurement is completed, all measurement results can be observed by pressing the button as shown in the figure.


6. Print real-time measurement results


This instrument can be equipped with a printer. After the measurement is completed, if you need to print the measurement results, please press the key to enter the measurement result display and press the button to print the data to the specified serial printer.


The instrument can select any parameter to print or print all parameters according to the actual test requirements of the user. For how to set the parameter selection, please refer to “Print Settings”.


Previous: Roughness instrument maintenance

Next: The basic principle of ultrasonic thickness gauge