Contact Us
TEL: 86-010-82675282
Fax: 86-010-82675633
E-mail: susan@kaida17.com
Address: Floor 2, Building C, No. 3 courtyard, Jinbangyuan North Street, Xisanqi, Changping District, Beijing 100096, PR CHINA
Home > Knowledge > Content
Ultrasonic thickness gauge operation steps
Nov 22, 2018

Ultrasonic thickness gauge operation steps


Let's talk about the operation steps of the ultrasonic thickness gauge.


a) Prepare the workpiece to be tested;


b) Insert the probe cable plug into the socket above the main unit and tighten the plug;


c) Select the working power supply according to 2.1.3, press <ONKEY> to turn on the machine;


d) program loading and power-on self-test;


e) Under normal conditions when booting, it automatically enters the state when it was last turned off. The instrument parameters are the same as when it was last turned off, but the waveforms from the last shutdown are not displayed. When the power-on self-test is not normal, you can shut down and restart again. If the self-test still fails, you can force reset to the factory state (see 3.14.10).

f) Check the battery voltage. If the battery power detection icon is as shown in Figure 2.3, if the battery is low, it will automatically shut down after the alarm ring sounds for 1 minute.


g) Whether it is necessary to calibrate the instrument and draw the DAC or AVG curve, if necessary, professional and technical personnel to carry out related operations (see Chapter 4);


h) call up the parameter settings of the corresponding flaw detection channel;


i) measurement;


j) store the data that needs to be saved;


k) shutdown;


Previous: Thickness gauge use precautions

Next: Ultrasonic Thickness Gauge Features